AEM CAI Bracket HELP!

[ZigZag]

I need HELP PLEASE! I'm installing my AEM CAI and have gotten
all the stock stuff out. I need to bend the bracket that holds the grounding wire.
But that thing is hard to bend.
Here is a picture of what i'm talking about.
http://members.aol.com/Squiglee/CAI/bracket1.jpg


Here is a closer shot

http://members.aol.com/Squiglee/CAI/bracket2.jpg

How do i bend this bracket?!? I read the projects page and he
just removed it... only thing is i dont know how he did it.
Do i need to get under the car... i only have 2 jack stands.Any suggestions would be appricated!

[greenguy]

Use a 12mm socket and some elbow grease and just remove it. Relocate the ground wire to the right (I think) of that spot. You should see the new spot.
BTW: you do this from the top.

[fsugatorbait]

When I installed mine, I just removed it and it fit back in the same location when I was done...check to see if that works for you.

[jaydub]

I didn't move that. :confused: :D

[ZigZag]

Thanks All! I managed to fit the tube in without any relocation of the bracket
( i fished it in from the bottom to the top).
I set everything back in place, except the hoses.. the hoses are
installed on the intake, now i need to place them on the engine...
do i need to remove the stock (smaller) gray one from the engine and replace it completely with the given one, or just
attach it to the stock one. How do you get the larger on without cutting it? Thanks in advance!:)

[ZigZag]

Thanks to all who responded... just a little more time and got the hoses back. The sound is very nice. :cool:

[Jpax]

I think your ZigZags are kicking in. ;) :D Tell us what you think of the intake when your done.

[Makross]

yeah i would like to hear some input too im gettin mines tuesday:p