PDA

View Full Version : SouthHonda.....Atlanta, GA



SouthHonda
05-04-2003, 07:46 PM
FIgured I would go ahead with a mod list and pics of some of the stuff. The mods with an "*" after them mean there is a pic in this post of the mod.


Interior:
Momo chrome shift knob & modified stock boot *
Stinger digital voltmeter*
Inverted Hazard switch (just to be different)*
Note: This is meant to be a joke. I in no way think this adds to my cool points.
Hyperwhite dome and maplights
Blue tinted 270mm Broadway Mirror

Stereo:
Stock rear speakers
JL Audio 6 1/2" mids and 1"tweeters in Front
Eclipse In-Dash Flip out TV
Eclipse In-Dash 6 Disc Changer
Alpine MRV F400 V12 Amp

Engine:
AEM Cold Air Intake
AEM High Volume fuel rail
Hondata Intake Manifold Gasket
Spoon Race spec muffler section
Spoon radiator cap type D*
Spoon Magnetic drain plugs (oil & Tranny)
Spoon resovoir covers for brake and clutch masters*
Mr. Alex engine torque damper*
Buddy Club titanium oil cap

Suspension:
Ground Control coil-overs
Ground Control camber plates (F)*
Specialty Products adjustable upper control arms (R)
Neuspeed Lower X-Brace
Neuspeed rear sway bar w/support plate*
Mr. Alex rear upper strut tower bar*
Mr. Alex C-pillar tie bar*

Exterior:
CTR Union Jack Badge
Honda red bumper lenses (F)*
Yellow H4 headlight bulbs
Yellow 194 parking light bulbs

Soon to Come:
AEM Big Brake Upgrade Front & Rear (on the way)
CTR red H's front & rear
18" Centerline RPMs in machine finish (eternal back-order)
Mr Alex front upper strut tower bar
Spoon front lower tie bar
Injen polished intake cover
Honda S2000 start button
Neuspeed front sway bar
Wings West mid wing

Scott

SouthHonda
05-04-2003, 07:47 PM
GC drop on stockers
http://www.imagestation.com/picture/sraid61/p1de4fae29f20a9cad22e8fbebbecbec4/fc368819.jpg

SouthHonda
05-04-2003, 07:57 PM
Mr ALex Damper
http://www.imagestation.com/picture/sraid61/p740ed1a954aee31b7ddcc048077ae7da/fc368816.jpg

The CTRs have a strut bar from the factory that the instructions show and it is supposed to bolt under that but I had to mount it to the strut bolt. Now I gotta drill another hole for a second bolt.
Modify or die!!

Spoon Rad Cap...Actually works...Car runs cooler
http://www.imagestation.com/picture/sraid61/pd57e9d972548451ef3ae482f3bee0c39/fc368818.jpg

Spoon reso covers and ground control camber cups
http://www.imagestation.com/picture/sraid61/p755f974689925f500bd6719ac6bbb402/fc36881e.jpg

You can also see the A/C line I started polishing out. There are plenty of things under the hood to Xtreme.

SouthHonda
05-04-2003, 08:03 PM
Neuspeed rear sway bar plate
http://www.imagestation.com/picture/sraid61/p0f5963081441c5e6b13593200e792a01/fc368a30.jpg
Pretty cool piece...very heavy duty...and the guy thats loosing to you can see it from behind the car....haha

Mr Alex rear strut bar
http://www.imagestation.com/picture/sraid61/p9fba7e29a4905e99aecd5977031766b7/fc368826.jpg

Right now its under the carpet but I am going to make it sit on top of the carpet somehow

Bad pic of Mr alex C-pillar bar
http://www.imagestation.com/picture/sraid61/pf98dddffd5ed736f9062adccb4fff186/fc368652.jpg
Lost the other pic from the inside. It sits even with the rear wiper in my rear veiw mirror and I can open the hatch and cover without it getting in the way.

chet
05-04-2003, 08:32 PM
I was curious how you like your Mr. Alex damper. I ordered a J's Racing damper and should get it within a day or two. Nice clean car by the way!!

SouthHonda
05-04-2003, 08:42 PM
check out my post in the Engine forum..same pic. It was definitely worth the money.

I can launch a lot harder. Still get wheel a little wheel spin off the line and about the same when I snatch second.

golferjn
05-04-2003, 08:50 PM
nice car

SouthHonda
05-04-2003, 09:15 PM
Shift knob, volt gauge, and the inverted hazard switch (the most extreme mod ever!!)

http://www.imagestation.com/picture/sraid61/paca40c51264a3469ebb4a4a1ff599046/fc36882d.jpg

Scott

AznPower
05-05-2003, 09:41 AM
nice setup. how much was the rear sway wit the support plate. what does it do besides looks?

SouthHonda
05-05-2003, 10:54 AM
There was some talk going around that swapping out to a larger rear sway bar would cause the rear "subframe" (where the stock bar mounts and the lower control arms bolt in) area to flex badly so neuspeed came up with this. Progress also has an extra support for their rear sway bar.

The rear sway bar kit includes the bar, new poly bushings, bolts for everything and the plate. Its sold only as a kit.

Scott

IceD out N CALI
05-05-2003, 11:19 AM
nice car. i like all the suspension goodies u got for it

BlackNRedSi
05-05-2003, 12:43 PM
very nice!

you going for the sleeper look?

eric

iVtec si
05-05-2003, 01:55 PM
what up man, nice to finally see some pics of your ride. I'll probably see ya in a week or two when I need my next oil change.

peace

Chris

SouthHonda
05-06-2003, 09:36 AM
very nice!

you going for the sleeper look?

eric


actually I am going for the opposite look. When my wheels finally get here, I will decide which body kit I want to go with. And I am waiting for a CF hood with some kind of funky scoop in it (something besides the mugen or VIS styles).

And knowing me I will change my mind more than once before I am done.

Scott

BlackNRedSi
05-06-2003, 09:39 AM
GOOD LUCK WITH IT!!!!

JoshSI
05-06-2003, 11:02 AM
Where did you get the Spoon reso covers?

Peking
05-06-2003, 11:29 AM
Good that you posted some pics. Trust me when I say that the pictures don't do the car justice. Great mods so far. :D

JoshSI
05-07-2003, 07:56 AM
Originally posted by SouthHonda
I sell them. Give me a call at work and I will give you a good price.

770-968-5977

Scott

Can you get the Mr. Alex damper too?

What is the name of your business and all give me some 411