siver-SI
06-25-2003, 09:07 PM
Ok I am getting my self ready to do some work on my car in the next month. I have money coming in and all most all my tools I need now I am just trying to figure out how to get my EP off the ground so it is completly on jack stands. On my 88 Prelude I can take a 2x4 and run that right down the side of the car under the door were there is a subframe and jack my car one side at a time. When I looked under my EP the subframe is a lot diffrent in looks. What I am trying to figure since I do not have a lift how do I use my Hydrulic jack to get under the car and then try and place a jack stand under that area of the car. When I look at the manual there is only one place to jack up the car and I do not see a place for the stands to go since the jack is in the way.
I am just afraid of going through a floor board or bending something so that is why I am asking. I would just like to use the jack and that since with the car off of all 4's I will have about 3 feet under the car to work. I am trying to get all my money togther for the springs, Progressive x brace, and the progressive Rear lower tie bar. I will also get the camber kit. I just hope to get all my cash together by this weekend so I can order this weekend or next week.
Thanks
I am just afraid of going through a floor board or bending something so that is why I am asking. I would just like to use the jack and that since with the car off of all 4's I will have about 3 feet under the car to work. I am trying to get all my money togther for the springs, Progressive x brace, and the progressive Rear lower tie bar. I will also get the camber kit. I just hope to get all my cash together by this weekend so I can order this weekend or next week.
Thanks