02SilverSiHB
07-26-2003, 01:31 PM
For those not familiar with it, here it is:
shift light
http://a7.cpimg.com/image/FD/29/21547517-6e66-02000180-.jpg
control unit for selecting rpm's for green and rpms for red lights
http://a3.cpimg.com/image/E5/28/21547493-cd23-02000180-.jpg
The Red comes on when you reach the max rpms you want.
The green lights up when you are at the rpm you want for launching at the strip. This can also be set for autocross to where if you fall below the desired rpm it will light up. You just press a switch for the desired affect you want, either above or below the preset rpms.
When I start the car, the green light is on and I have it set to come on when it goes below a certain rpm (not sure what rpm, but the knob is turned to a low setting)...to test it out. I rev it all the way and the light doesn't go off. The red one doesn't come on either when I hit the rev limiter and I have the red rpm set to a low setting to come on.
There are 6 switches in the rear and I have no idea what to set them at. The manual is written in poor english, but sounds like I should have the switch down for 4, meaning I have 4 cylinders. So I'm not sure if I have that part correct, or if I have the thin black wire spliced into the wrong blue wire.
http://a4.cpimg.com/image/04/29/21547524-0e15-02000180-.jpg
shift light
http://a7.cpimg.com/image/FD/29/21547517-6e66-02000180-.jpg
control unit for selecting rpm's for green and rpms for red lights
http://a3.cpimg.com/image/E5/28/21547493-cd23-02000180-.jpg
The Red comes on when you reach the max rpms you want.
The green lights up when you are at the rpm you want for launching at the strip. This can also be set for autocross to where if you fall below the desired rpm it will light up. You just press a switch for the desired affect you want, either above or below the preset rpms.
When I start the car, the green light is on and I have it set to come on when it goes below a certain rpm (not sure what rpm, but the knob is turned to a low setting)...to test it out. I rev it all the way and the light doesn't go off. The red one doesn't come on either when I hit the rev limiter and I have the red rpm set to a low setting to come on.
There are 6 switches in the rear and I have no idea what to set them at. The manual is written in poor english, but sounds like I should have the switch down for 4, meaning I have 4 cylinders. So I'm not sure if I have that part correct, or if I have the thin black wire spliced into the wrong blue wire.
http://a4.cpimg.com/image/04/29/21547524-0e15-02000180-.jpg