View Full Version : remove cat
SpeedRacer
08-29-2002, 02:23 PM
i want to remove my cat real bad but what am i supposed to do so my check engine light will not come on? Can someone help me? Is thare any fake sensors i can use anything will help thanks.
2K2SilverSi
08-29-2002, 05:16 PM
there are sensor simulators you can buy. I dont know if they will work on an LEV though
SpeedRacer
08-29-2002, 05:42 PM
whare do i buy them and how do i find out if they work do you know?
ssvr6
08-29-2002, 06:28 PM
What are the sensors reading? Just air temps and such? Just hollow the cat out and keep your sensors plugged in. If that isn't the solution you're looking for, I know you can "fool" the sensors, I just don't know what part(s) you need.
Good luck,
Steve
2K2SilverSi
09-03-2002, 07:07 AM
I dont know where to get them but they really arnt all that much. I know if you go to and domestic shop they should have them there due to the fact that so many mustang guys get H pipes and need to trick their OBD 2 computers. They might even be able to tell you if they work for an LEV car. That is the only thing I am wondering if they will simulate low enough levels of CO2. The sensors read temps CO2 levels and onther things such as that.
00sir
09-03-2002, 07:48 AM
I posted about this a couple of weeks ago...
Do a search for "simulator" or "sensor"
Good luck,
Steve...
Oh yeah, hollowing out the cat would be bad...
You will definitely get a CEL if you do that.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.