View Full Version : How to shave rear wing?
djcubinlinx
08-15-2003, 08:16 PM
I did a search and came up with no pictures. I remember about 2 months ago, EPHatchgirl had a great thread on the install, but all the pictures are gone. If anyone can help, i would appreciate it.
:D
beansbear
08-15-2003, 09:19 PM
I think all you neeed to do is get a dremel or lots of elbow grease and sandpaper to take the ridges off the edges of the wing.
I remember seeing her pics and how she cut them off then fiberglassed over them to cover the hole.
djcubinlinx
08-16-2003, 06:26 AM
Yea, i think i remember. I just want to be sure of how much to cut off.
beansbear
08-16-2003, 09:39 AM
i think you should just start slow and keep going until it looks right. Thats what i would do in your situation!
good luck! post pics when you are done!
i hope this will help you:o
http://www.imagestation.com/picture/sraid74/p435a42e7fe7f2e0817095514c5c51963/fb5f8283.jpg
02CivicSI-VTEC
08-16-2003, 04:01 PM
what kind of tools did you use? did you bondle it with a fiberglass underneith?
i used a grinder to shave the mounts and then i applied bondo. ;)
02CivicSI-VTEC
08-16-2003, 06:31 PM
grinder you say?? how long did it take you? oh yeah any what kind of paper did you use to sand it down?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.