K24 w/65 Shot Dyno Sheet & Timeslips

[SiK24]

:)

[SiK24]

:)

[andy]

Sweet. I'm assuming you are car "155" on the time slips?
I guess you weren't using slicks? The first run looks like
high-13s with a better 60'...

[B17A]

Nice times on the K24. How much did the K24 run pricewise? It might be a fun little swap.

Also, when are you planning on doing the boosted G20?

[SiK24]

The k24 cost $1350

As for the G20, it will get a turbo as soon as I stop spending money on the Si.

[Ep_Hatch 03]

Nice Time

[speedology]

nice times, with a better 60 foot you should get in the high 13's for sure. wheed u get your motor from sound like a good price im interested

[SiK24]

I think it was called East Street Motor.

The cams should be on in the next week or two, will have updated dynos soon after.

[si hatch]

k24 swap? is dat teh whoel k24 motor or is it just the k24 block

[PAPITUYO326]

that k24 motor is nuts man...i really want to try this setup(few years only got 4500 miles on mine) ...all u needed was motor mounts correct??

[SiK24]

Its just the K24 block, everything else staid the same. Used all of the Si parts (trans, intake man., exhaust man., wiring, pumps, etc.) Didn't have to buy mounts either. Used all the Si mounts except for one (used the left (if you were outside facing the motor) upper CR-V mount). The swap was pretty straight forward!!!

[PAPITUYO326]

this seems like it definatly is the best bang for your buck swap....any recent mods or slips or stories?

[SiK24]

Not yet, but I promise the cams will be on in the next week or two. The nitrous box had to be sent out to get replaced, which should be in this week and the cams are already here. I will put up some dynos, but I doubt I will be around the car after this, time for me to move on after this is done.