DIY headlights and sealant

[phokingphosho]

I was wondering, how do you guys take off the sealant if it got onto your lens on your headlights? Goo-Gone? Gasoline? Any suggestions appreciated, thanks.

[TrippZ]

try wetting a paper towel with some lighter fluid for barbeques and just apply swirl it around and wipe off with a wet towel and then a dry one

[liljosh63]

put the headlamps in the oven on 250 degrees for 5 minutes. when u take em out just pull real hard, the sealant will be gooey.

[Go_EP_Go]

the whole process is easier if u have a heat gun

i finished mines in like less then 2 hrs i would think u could melt the sealant on the lens with the heat gun and wipe it off

[TrippZ]

Originally posted by liljosh63
put the headlamps in the oven on 250 degrees for 5 minutes. when u take em out just pull real hard, the sealant will be gooey.

hes talking about accidentaly putting some silicone or sealant on the front of the headlamp.

paul, try my method, whe nI bought my lamps from jared there was a little bit on my drivers light, i did what I said and it came off like butter.

[SinisterCivicSi]

i have to do the same thing, i got some on my lens too, thanks for the info.