Looking for a single gauge pod? [Archive]

fsugatorbait

02-09-2004, 02:48 PM

Ive read a lot of posts over the year ive been on here about people looking for a single gauge pod that will fit our car. I was reading a couple weeks ago on a site, cant remember which one, and one of the questions was if we had the same sterring column as the RSX. It was said we did, so I took a shot on the autometer steering column single gauge pod for the RSX and it works. I got it from "Club RSX" (http://store.clubrsx.com/merchant.mv?Screen=CTGY&Category_Code=ARSXGGP) for $40 shipped. Put it in this weekend with an a/f gauge. The only thing is there are no tabs on the bottom of the pod to connect to the stock bottom section. I used a two part epoxy that dries clear and ran a thin bead along the joint that worked great. Here a couple pics...

http://www.we-todd-did-racing.com/wetoddimage.wtdr/i=wMjY3MTU0NnM0MTNkZmQzMXk1NDE%3D.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/i=wMjY3MTUzNnM0MTNkZmQzMXk1NDE%3D.jpg

http://www.we-todd-did-racing.com/wetoddimage.wtdr/i=wMjY3MTU1NnM0MTNkZmQzMXk1NDE%3D.jpg

aRz

03-09-2004, 10:32 PM

where did you connect the violet (purple) wire,
i also have a (air/fuel) guage i placed it in the useless silver slot oposite the hazards button.
anyway did you connect the wire str8 to the 02 sensor, to the wiring harness or to the ecu..?> ive' heard of people doing all 3 which did you do and id it reading correctly ..
thanx