View Full Version : Clutch and flywheel
k2ep3
03-11-2004, 12:42 AM
Installed clutch and flywheel lately, and I took a picture of it, so I just thought it will be helpful to post instruction of it.
Link (http://www.geocities.com/k2ep3/howto.htm)
phatfreeza
03-11-2004, 01:52 AM
those are some very nice pics! good job... however.. it seems like a task too complicated for me to undertake... this is for the brave souls out there :)
k2ep3
03-11-2004, 08:24 AM
Actually, it wasn't that easy comparing to install intake, but I saved a lot like $400, $500 for installing. :D Well, if you have factory service manual, it shouldn't be that bad. I just thought this would be helpful.
Anyway, thanks.
!@#$%
03-17-2004, 02:41 PM
a manual and air tools. Air tools and a good tq wrench are must haves for a diy'er.
Nadal328
03-31-2004, 10:15 AM
U guys are crazy , this clutch was so hard, and ur directionns sucked real bad
k2ep3
03-31-2004, 12:27 PM
Originally posted by Nadal328
U guys are crazy , this clutch was so hard, and ur directionns sucked real bad
the pressure plate is hard, but it's driveable.
it's little heavier than what i was thinking though....
i post all the directions that is needed for the transmission part.
dyeownsme
05-04-2011, 08:37 PM
Link is dead. Help?
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.