View Full Version : progress sway bar question ASAP!!!
Black 02 SI
03-13-2004, 07:35 PM
anyone have their car lowered, rear progress sway, and magnaflow? i am lowered 1.5'' and i have magnaflow cat back. just wondering if there is enough clearance i have heard some sway bars hit the exhaust. let me know soon so i can order this stuff.
Lucid Moments
03-13-2004, 08:34 PM
I'm lowered with the Progress, I've got the stock muffler which is bigger then the magnaflow and there is no problem. HondaMan has the exact setup you're talking about and I've never heard him say anything about problems.
Black 02 SI
03-13-2004, 09:14 PM
well its not the muffler i;m worried about. the piping is much bigger that goes over the axle. but thanks for the input. i dont think it will be a problem but i like knowing for sure before i buy things.
i've got both (plus sportlines). no problem - plenty of room.
1fastminivan
03-13-2004, 10:55 PM
NemesisITR on here has that same setup....infact he did the install today.....and has no swaybar/exhaust rattle problems. He said the bar did the the piping just a little under a very hard corner. I looked under there and there is a lot of room. He has the prokit on his car also.
I am dropped 2" with magnaflow and progress sway, this combo = no problems.
rook
hothatch03si
03-14-2004, 11:15 PM
my friend has a 2002 civic ex and he gave me his progress rear sway bar it looks like it will fit but does anyone kno if it will
Civicvtec1ps
03-14-2004, 11:23 PM
Originally posted by hothatch03si
my friend has a 2002 civic ex and he gave me his progress rear sway bar it looks like it will fit but does anyone kno if it will
Will fit perfectly.
03silverEP
03-15-2004, 02:50 PM
the magnaflow doesn't have fitment problems it's just the HKS that hits 22mm sway bars
Black 02 SI
03-15-2004, 08:57 PM
nice, thanks for everyone's help. hope to have these and installed very shortly.
hothatch03si
03-15-2004, 11:18 PM
just instaled my progress sway bar today fit very good but the one big bolt on the i guess its the control arm won't thread all the way ....anyone help
fsugatorbait
03-16-2004, 12:45 PM
Originally posted by hothatch03si
just instaled my progress sway bar today fit very good but the one big bolt on the i guess its the control arm won't thread all the way ....anyone help
It sounds like it isnt lined up all the way. Try taking a no-bounce hammer to it. HTH.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.