pedzola
03-17-2004, 06:11 PM
Ok so I installed my eibach prokit this past weekend...
Couple of things...
#1) when we finished the install we noticed we had an extra bump stop (whoops). Too tired to take it apart again so I have a bump stop on one side in the rear and not the other. Exactly how much of a problem is this?
#2) Ripped one of those tie rod rubber boot things on the front... its still there... but ripped pretty good... might rip in half eventually... how vital is this? lol
#3) Do I need an alignment? How can I tell if I need an alignment? They can't adjust camber without a camber kit right? Is there anything I could have thrown out of whack by taking things apart and putting back together? People have always said you don't need a camber kit w/the prokit springs....
Do I need an alignment? Or not? Thanks!
:D
Couple of things...
#1) when we finished the install we noticed we had an extra bump stop (whoops). Too tired to take it apart again so I have a bump stop on one side in the rear and not the other. Exactly how much of a problem is this?
#2) Ripped one of those tie rod rubber boot things on the front... its still there... but ripped pretty good... might rip in half eventually... how vital is this? lol
#3) Do I need an alignment? How can I tell if I need an alignment? They can't adjust camber without a camber kit right? Is there anything I could have thrown out of whack by taking things apart and putting back together? People have always said you don't need a camber kit w/the prokit springs....
Do I need an alignment? Or not? Thanks!
:D