PDA

View Full Version : Removing gauge needles



cpu519
04-04-2004, 11:23 AM
Anybody replace the gauge face on their EP or another Honda or other car? How do you remove the gauge needles? Is there a catch that needs to be disengaged or do they just pull off? I don't want to risk damaging the cluster by doing this wrong. Thanks.

WideBody EP3
04-04-2004, 03:37 PM
DO NOT TAKE THE NEEDLES OFF!!!!! you can manuver the guages over the needles. with out removing the needles,

cpu519
04-04-2004, 10:56 PM
I'm going to scan my original gauge face and make a custom one with an extended rev range, to 9000+ rpm to accomodate my Type R engine. So I need to remove the needles so I can take off the gauge face. From what I've been reading a tool is needed to remove the needles, maybe a pin or something. Not sure if that applies specifically to the EP though.

WideBody EP3
04-05-2004, 07:19 AM
if i were you i would go to MMRUSA.com and they make custom guages any way you wnat them and order them from there then slip those over your neddles in your cra