View Full Version : Removing gauge needles
cpu519
04-04-2004, 11:23 AM
Anybody replace the gauge face on their EP or another Honda or other car? How do you remove the gauge needles? Is there a catch that needs to be disengaged or do they just pull off? I don't want to risk damaging the cluster by doing this wrong. Thanks.
WideBody EP3
04-04-2004, 03:37 PM
DO NOT TAKE THE NEEDLES OFF!!!!! you can manuver the guages over the needles. with out removing the needles,
cpu519
04-04-2004, 10:56 PM
I'm going to scan my original gauge face and make a custom one with an extended rev range, to 9000+ rpm to accomodate my Type R engine. So I need to remove the needles so I can take off the gauge face. From what I've been reading a tool is needed to remove the needles, maybe a pin or something. Not sure if that applies specifically to the EP though.
WideBody EP3
04-05-2004, 07:19 AM
if i were you i would go to MMRUSA.com and they make custom guages any way you wnat them and order them from there then slip those over your neddles in your cra
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.