bumper lenses

[grooveline]

has anyone removed their bumper lenses? I need to replace one that I broke. every time i follow the directions to remove them, the bumper ends up distorting where I am putting pressure.

how hard is it to do this? ex: the rear bumper.... i know I have to push the back edge of the lense to the front and then it will pop out... but it ain't workin. the bumper just bowes in.

any help is appreciated.

[STP03BlueSI]

Take off the bumper. Then you wont end up damaging the bumper

[NuG]

the back one is easier than the front. For the back ones you can reach behind the bumper and work them out. It's much easier because you can see the part that is clipped in from the back. good luck

[halos02Si]

turn the tire your working on inward....pop like 2 of the lil plastic tabs out and pull the black plastic part above your wheel just enough to squeeze your hand in....that should help you snap it out from inside....hope it helped a bit :)

-breandly