ITR pedals in an 04 SI?

[archman]

Does anyone know if the ITR pedals will fit easily in an 04 SI? Thanks for any help guys!

[SiN05]

you were reading my mind I was planning on asking this question. Also I wanna know where u can get the matching dead pedal?

[SiN05]

http://img141.imageshack.us/img141/9739/nc8n8729ps2.th.jpg (http://img141.imageshack.us/my.php?image=nc8n8729ps2.jpg)
for those of you who donno

[02TWSI]

I dont know about the ITR pedals, I think they require drilling.

If you haven't already purchased them i'd look at http://www.strutking.com/civic-39-01-39-05-/civic-sport-pedals-01-05-mt-/prod_17.html

It looks the exact same.

[v1c10us]

the dead pedal is ovalish and ours is square so that would look dog ugly

[spydur]

I've had the Strut King pedal covers for approximately a month and I really like them. They are made out of stainless steel, fit well and look nice. The only negative fact about them is that the mounting screws, bolts and nuts are not stainless therefore, they will rust. I'm going to replace my mounting hardware with stainless ASAP.

S P Y D U R
SAIL-ON!

[rspjean]

I dont know about the ITR pedals, I think they require drilling.

If you haven't already purchased them i'd look at http://www.strutking.com/civic-39-01-39-05-/civic-sport-pedals-01-05-mt-/prod_17.html

It looks the exact same.

might be picking this up

[thisisagame24]

might be picking this up

dooo it..... just installed mine 2 nights ago...real easy and looks sessy. and a hell of alot cheaper and easier to install then itr pedals

[OZ.EP3]

Here's what they look like installed, I used a black plastic folder to cut out the backing for the dead and gas pedal. Otherwise you'll see your grimy rubber pads thru the holes . . .

http://i257.photobucket.com/albums/hh226/Clean93teg/IMG_3264.jpg

[!@#$%]

yeah just get the strutkings.

i have them and they are a fantastic oem equivalent at a fraction of the cost.

[stealth]

But if you must be baller check here on the dc5 page halfway down on the left.
jdmland.com

[shivic]

Here's what they look like installed, I used a black plastic folder to cut out the backing for the dead and gas pedal. Otherwise you'll see your grimy rubber pads thru the holes . . .

http://i257.photobucket.com/albums/hh226/Clean93teg/IMG_3264.jpg

the pedals look good but the climate control bezel looks great. is that the carbon insert or is it painted.