Speaking of pinstripes... what about the iVTEC decal?

[BarracksSi]

What if I wanted to take off the i-VTEC decal on the side?

[LazyAzzAzian]

check this thread http://ephatch.com/forum/showthread.php?s=&threadid=3529 (http://), basically you can use a blow drier, or heat gun (if you have one) to heat up the sticker and it should peel off easier

btw do you happen to know how to make the tail light light up like your avatar?

[BarracksSi]

Duh, ok, I should've tried searching... :confused:

In my pic, it was a daytime shot with a flash. I had taken some other pics before with a flash from other angles, and noticed that the reflectors seemed to light up. So, I tried it from the rear, and it was the first time I got to see what the taillight reflector pattern looked like.

[TrippZ]

Originally posted by LazyAzzAzian
check this thread http://ephatch.com/forum/showthread.php?s=&threadid=3529 (http://), basically you can use a blow drier, or heat gun (if you have one) to heat up the sticker and it should peel off easier

btw do you happen to know how to make the tail light light up like your avatar?

DO NOT I REPEAT DO **NOT** USE A HEAT GUN FOR ANYTHING ON YOUR SI'S BODY!!!

Heat guns make extreme, concentrated head. One can only imagine the kind of damage it can do to the paint. Just use a blowdryer.

[ssvr6]

Just use your finger nail, some goof off and some elbow grease.

Steve

[SubliminalSi]

*agrees with ssvr* and if you dont have fingernails (short, bit-up ones like me) try using a toothpick