ABS Light/slice in wire?

[ALep3]

Well my ABS light has been coming on now and then so I decide to check it out yesterday. I found a split wire on the back drivers side it's cut right where it sits on the camber bolts between the 2 clamps. My question is can I just cut this and splice them together or do I need to replace them? If it needs to be replaced does anybody have a part #. Last but not least where does the wires connect to? I know where it goes on the hub but it looks like it might go all the way up front. Anybody have a diagram?

[ALep3]

bump

[talonXracer]

You should be ok with splicing them together as long as they are soldered and completely insulated. I slide a piece of heat shrink tubing over the wire, then wrap the ends around each other. Now solder them together, and apply some liquid electrical insulation(let it sit for an hour) and now pull the heat shrink over the spliced area and shrink it. You now have a waterproof splice.

[ALep3]

thanks talon it will save a bunch of work that way!