a2 head with a3 bottom

[vbp04]

so i am getting an a2 head for like 200 bucks from my friend,, i would like to know what is the cheapest way for me to bolt the head onto the a3 bottom? can i still use the stock ecu? is there anything i have to change? i tried to search, but nothing really helped.. thanks guys

[LaoKidd2k]

you pretty much need everything for the type-s. injectors, spark plugs, new head gasket, intake manifold gasket, and etc. you will need to run kpro for the sway to work properly. that way you can tune it

[talonXracer]

You will need Kpro, head gasket, fluids and misc stuff. It is ALOT of work.

[LaoKidd2k]

like me it took me 2 days in the middle of summer, with no experiance at all with honda engines

[EPandaman29]

get ready for one big headache after another...its a LOT of work to get that combo running right...but good luck to ya. it'll all pay off when yourre done.

[LaoKidd2k]

you'll need a lot of energy drinks just to get you through the day. i went through maybe 5 a day with alot of water

[jaeguyoon]

took me and 3 other ephatch members 6 hrs for a head swap.

[the JigGa mAn]

you pretty much need everything for the type-s. injectors, spark plugs, new head gasket, intake manifold gasket, and etc. you will need to run kpro for the sway to work properly. that way you can tune it

look for a k24 block, and then put the head on that!

[JP_909]

look for a k24 block, and then put the head on that!

yup save and go with a k24.

[shadowmd]

its a decent amount of work, but not too bad. i put my head back on myself in under 3hrs. but i have a full a2 swap. just make sure u tq. everything down in the right sequence and to the right specs