What speakers i need?

[hothatch]

Im looking to replace the stock speakers in my ep3 and i was wondering what sizes i needed for every speaker in the car because im going to order the online asap and get my system rolling.

[devious05]

i think the stock ones are 5 1/4" but with a little moding i put oversize 6 1/2"s in my door. what are you getting coaxles or components?

[powdbyrice]

i have some nice 6" bostons that i'm looking to get rid of... new in box... i know they fit in the front...

[the JigGa mAn]

i think the stock ones are 5 1/4" but with a little moding i put oversize 6 1/2"s in my door. what are you getting coaxles or components?

stocks are 6 1/2" all around front and rear, i have replaced them with 6 1/2" all around and only the back needed to be modded because the magnets were too big to fit

[devious05]

my cdt's would not fit in the hole in the door at all. i had to mount them on a 3/4" ring for width and depth clearence.
http://www.cdtaudio.com/cdt_new_0607/CL-62-w_480.jpg

[Chad]

Many front drivers will need a ring to make them clear, then you need to look at other issues, likely you will need to carefuly knock down the ring inside the door card, no biggie. I also found that moving the driver forward and down in the door allowed it to clear the area of the door-card where it narrows at full excursion.

I run a Seas 7" that is not shallow by any means, I'm using about 1" of ring moved forward and down and I have about 1/4" of clearance to the rear fo the driver and a bit less than that at full driver excursion.

[Teejay]

I used orion 5 1/4" component set. Speaker cleared perfect without a ring and tweeter fit great with a lil help from the rotozip. In the rear i have 6 1/2" power bass mid drivers.