View Full Version : Anyone have Valve Adjustment DIY?
dann_04
06-02-2008, 09:01 PM
Can anyone repost the DIY Valve adjustment from a while back? It was really good and had pics and all and then it got lost in the crash i think. Was going to tackle the valves soon, but couldn't find it. Thanks
SimonEp3
06-10-2008, 05:29 PM
Yeah, I was thinkin about doin mine to, anyone who can find the DIY your help would be greatly appreciated.
oneglory
06-10-2008, 06:06 PM
I have the old thread printed out on paper.
How often do you need to do this?
mormonboy
06-11-2008, 02:34 AM
someone post this up. id like to know as well.
audleon
06-12-2008, 05:06 AM
I found one buried in another post. If you go to the DIY section and find the post by Jimmyjames called "replacing your intake cam" I think it's on the 3rd page of DIY forums, you'll see down near the bottom, he has a pretty detailed write up on the process.
Hope it helps,
audleon
powdbyrice
06-12-2008, 03:04 PM
search foo!
http://www.ephatch.com/forum/showthread.php?t=44979
oneglory
07-12-2008, 07:18 PM
again, i still have this on paper, if needs be I we retype it.
BeaterEP
07-17-2008, 12:43 PM
I'm thinking it might need to be re-typed, or that link needs to be fixed. Whichever comes first. :mtongue:
BobSassafrass
07-24-2008, 08:13 PM
http://http://www.vtec.net/articles/view-article?article_id=143824
Here is a good DIY i followed to do mine!!!
Your link has one too many hhtp://
Fixed: http://www.vtec.net/articles/view-article?article_id=143824
Great DIY but are the clearances for the A2 going to be the same as the A3?
oneglory
07-24-2008, 09:04 PM
I will re-type it this weekend.
BobSassafrass
07-24-2008, 10:57 PM
I just downloaded the service manual and I think these are the correct numbers:
Valve Clearance (cold): Intake - .21-.25mm
Exhaust - .28-.32mm
Intake is the same as the A2 but the exhaust is .03mm higher on the A3.
03ep3 stapel
07-26-2008, 01:36 PM
i need to check mine
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.