View Full Version : k24a1 valve adjustment
MR.Pizza
06-13-2008, 01:53 AM
Can I use the same clearances for the k24a1 as the k20a3? By the way believe I have the DIY saved if someone wants to help repost it.
MR.Pizza
06-13-2008, 08:57 AM
bump this sirs
MR.Pizza
06-13-2008, 06:57 PM
intake .008-.010
exhaust .010-.013
Turned out my valves were dead on, no adjustment needed.
T_Virus
06-13-2008, 07:54 PM
what made you prompt to do a valve adjustment?
MR.Pizza
06-13-2008, 09:37 PM
what made you prompt to do a valve adjustment?
I'm tuning for power and wanted to eliminate that as a source of knock. Turns out my dump tube was just a hair to close to the downpipe and was rattling it when I was wot. All is good, Papy's motor was clean as they come.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.