Check Engine Light

[Sucka]

I have kpro and i just removed my jrsc-r kit and put everthing back to stock and now the check engine light is on

In Kpro it says

Code: 0 P1607 ECU Internal Circuit Malfunction
Code: 107-1 P0661 Intake Manifold Runner Control Low Voltage

What do i have to do to get rid of all this? I'm need to pass State Ref this week too!!!

Thanks

[thisisagame24]

i think whe you installed the new map you put a base rsx map instead of the civic si map. i did the same mistake when i first got kpro. because they both run k20a3 but different intake manifolds...... the base rsx has plastic onewith runners in it while we share the a2 one. i would reload the map and make sure its one for the civic si

[mystery1]

Wanna sell your SC? oh yea about your CEL...P0661 is an code for the RSX intake manifold runner...as mike said. I have replaced that damn plastic thing a few times on them...its kinda of a weird set up. Reprogram the ecu with the right KAL and you will be good to go man. Mike hit it all dead on but only because he has done the same.....damn ny guys are always in a rush and load the first kal they see.


JaY

[talonXracer]

You can disable that CEL in Kpro,,open parameters and then hit the VTEC tab and it will be on that page.

[mystery1]

but he has to pass the inspection coming up so he should do it the right way real quick and call it a day instead of by passing it...not sure if it will give any issuses with inspection if he does it that way.


JaY

[fEPst3r]

ok besides the intake manifold runner cold. this is the real prob. Code: 0 P1607 ECU Internal Circuit Malfunction, another member on here has the same code and when you clear it, it comes right back.

[Sucka]

ok besides the intake manifold runner cold. this is the real prob. Code: 0 P1607 ECU Internal Circuit Malfunction, another member on here has the same code and when you clear it, it comes right back.

Yeah what do i do about this?

[Sucka]

I load up the map for k20a3 civic si factory though. but i'll double check to make sure.