PDA

View Full Version : Kpro gurus help!



classiccelica
07-08-2008, 01:06 PM
Ok I am getting a lot of knocks at 2200-2750rpm, at part throttle. On kmanager which columns are for part throttle opperation?

AUTiger
07-08-2008, 01:27 PM
I thought it is 1-7 for the most part. I'm not certain though, I just got k-pro installed this weekend and have a lot to learn before I mess with it.

classiccelica
07-08-2008, 02:11 PM
Well I have had it for over a year but I haven't really had to tune it very much cuz I was happy with it then I retuned it from scratch and can't remember which columns are for part throttle I know that 7-10 are full throttle.

4angrybadgers
07-08-2008, 02:58 PM
Set Kmanager so it follows cam angles and VTEC through the datalog. Then load the .kal and the datalog, and go to the point where the knock occurred. The .kal will have 4 cells highlighted in red - those are the "active" cells at that point in time.

clutch797
07-08-2008, 06:54 PM
I have tried everything to get knocks out of my setup from 2750-3500rpm's and i can't get them all out. I did get them from 40 to 12 to 4 knocks so i'm happy. It also seems the knock sensor is full of shit so don't believe what it says.

talonXracer
07-09-2008, 06:10 AM
Do a valve lash adjustment, that is the range that you get vtec xover.

davisj3537
07-09-2008, 07:15 AM
To clear up something
Idle-1 through 3
Cruising- 3 through 7
WOT- 8 through 10

talonXracer
07-10-2008, 07:33 AM
After adding a set of IPS K2's, the idle moved up higher, columns 3-4(sometimes column 5 was hit). You can change the map reading that each column utilizes to help smoothen out the fuel/ignition maps.

LAvtec818
07-12-2008, 10:26 AM
To clear up something
Idle-1 through 3
Cruising- 3 through 7
WOT- 8 through 10

yea that