PDA

View Full Version : Rear Camber



v1c10us
07-29-2008, 05:15 PM
I got an alignment today, its still pulling a little funny, not sure if thats because of my rear camber issue.
my camber arms are rusted solid and cannot be adjusted; i wanted 2.0 degrees of negative camber in the rear, they couldnt do it but i just so happened to have 1.8/7and 1.9 in the back negative that is.
is this difference enough to make my car pull to the right a little?
The fronts were like -.7 -.8 and the toe is all good.

ep_hatcher_510
07-29-2008, 05:24 PM
hows tire pressure? did u check before the alignment?

nizmoluvep3
07-29-2008, 05:59 PM
do you have a rear camber kit??? tire pressure or maybe a tie rod?

v1c10us
07-29-2008, 11:01 PM
not sure on tire pressure
I replaced the tie rods and thats why I went to get an alignment because i messed up my toe.
I have a rear camber kit but its frozen at 1.8 and 1.9 negative camber

ep_hatcher_510
07-29-2008, 11:18 PM
not sure on tire pressure
I replaced the tie rods and thats why I went to get an alignment because i messed up my toe.
I have a rear camber kit but its frozen at 1.8 and 1.9 negative camber

the camber u got got now wont do anything to make the car pull. Definetly check tire pressure to see that they are all even, and maybe check the tie rods ends to make sure they are tight?