PDA

View Full Version : K24a1 swap into a 2002 EP3_Basic questions



Agent-Smith
08-16-2008, 04:57 PM
Ok I have a complete 2005 CR-V wrecked of course. I want the K24a1 in my EP. I dont want to turbo, supercharge or anything just N/A. What exactly will I need as far as down pipes, mounts and the ECU. I plan on putting my k20a3 intake on the k24a1, can I use my stock EP3 ECU to run the car, can I do that? I just need some advise on this K stuff. Thanks :beerch:

wishbear
08-16-2008, 05:19 PM
you would need some type s injectors which are 310s and passenger side mount

clujalolo
08-16-2008, 06:17 PM
yes you can use ur ep3 ecu but it will run rich if im correct. as for header goes, umm i belive you can use your stcok header but may need to remove the front sway bar for clearence issues. and you can use your stock injectors but i would just get some 310s so it doesnt run so rich,......i may be confusedt tho, hopefully someone chimes in who knows his stuff.

Agent-Smith
08-16-2008, 07:09 PM
So if i get some 310 injectors I can run my stock EP ecu with out running lean?

Kerby
08-16-2008, 07:38 PM
you need the side bracket not the mount. mounts are the same.

go with a rsx-s race header so you won't have any issues with clearence.

you might as well get kpoo. sooner or later you going to need it. get it done and over with now.



--sent from my pda.... hahaha

lldiesel386ll
08-16-2008, 09:03 PM
http://www.ephatch.com/forum/showthread.php?t=43890
http://ephatch.com/forum/showthread.php?t=43521

its been covered...over and over and over again:shakehead:

thechromecoyote
08-17-2008, 05:15 AM
^ yeah, we have an actual FAQ on this subject :mwink:

but if you want to run without ECU mod, keep the cat and run 310's, a RH might lean you out too much. You can get your downpipe lengthened the 10-15mm at any exhaust shop for cheap.

03Si757
08-17-2008, 07:00 AM
If you run on stock ECU with 310 type s injectors, dont plan on throwing a race header or CAI on there, itll throw you towards running lean.

wishbear
08-17-2008, 10:37 AM
just save for kpro then get all the bolt ons you will be satisfied

davisj3537
08-18-2008, 08:47 AM
I was gonna chime in but you guys already covered everything.