Which intake for a k24a2 and tsx IM?

[davisj3537]

Well I swapped one in for a customer but had to fab up a shitty little intake untill buying a good one. What are you guys running? I was assuming just buy an intake for a tsx?

[2004ep3hatch]

I took a knockoff aem v2 and made the filter end the tb end. cut 3 inches off the new filter end and then made a little bracket to hold it on.

I have the whole setup in the basment :mbiggrin:

[Slip_Angle]

I custom built my intake for the TSX IM. The intake I had sat too high and the hood pushed down on it.

[clutch797]

I'm running the stock air box with a custom intake pipe.

[davisj3537]

Dang! I was hoping to hear something good...you guys see any reason why an aftermarket tsx intake would not work?

[talonXracer]

You will have to do asome fab work to get it to fit the MUCH smaller engine compartment of the EP3. You would be far better off to simply piece on together using pipe from other CAI's and some silicone sleeves to connect the pieces together.

[davisj3537]

Poop! I just stuffed him a filer onto the stock elbow and it works...I guess we might just leave it at that:mredface: Anyone else?:mconfused:

[2004ep3hatch]

Poop! I just stuffed him a filer onto the stock elbow and it works...I guess we might just leave it at that:mredface: Anyone else?:mconfused:

the best thing to do is have a custom one made that is exactly like the old injen the goes behind the battery. Or you can buy the old injen and make the tb custom.

Just thought of this now lol

[Mr_Safeway]

Bump!


Can I use my injen sp1576?

[WhiteComet]

would the ep3 comptech icebox fit with the k24a2?