Exhaust hitting my Progress sway bar

[Amoney47]

i have a greddy ti-c with a progress sway bar and its hitting like crazy. my car is lowered 2 and a half inches and even adjustable endlinks might no fix the problem. what should i do??

[moso]

either run under axle exhaust, get rid of the exhaust, or get a new sway bar because a lot of people have the same problem

[nos4mao]

Im having the same problem man! I own the Ti-C and the CTR rear sway and Im having banging issues! I have the Corsport endlinks too and Im still having issues!

Thanks,
Matt

[mustclime]

progress bars have this problem....

[SinisterCivicSi]

its only with some exhausts... not all.

you can bend your exhaust hangers slightly to lift it off the bar or place some radiator hosing on your bar and zip tie it... thats what i did with my hks exhaust. mine never tapped until the swap.

[moso]

if you lift it up it will hit the floor panel i have the apexi n1 with the 24mm solid progress sway and i have no problems only when making tight left turns it raddles a lil bit but i am going to run under axle

[ep_hatcher_510]

Cut axle back pipe, place 1/2" - 1" pipe extension in, weld it, done.

[jw1]

I ended up bending the support tabs and taking a hammer to the exhaust to massage it a little. After a while I ended up just taking the muffler off.

[moso]

thats why i think the best thing to do on our ep's if we have after market sways and mainly progress is to run our exhausts under axle plus it looks damn sweet

[nos4mao]

What if I dont access to welding my exhaust? Could I solve the problem by getting stiffer hangers or would heat wrap be the best solution! If Im going turbo, should I keep my exhaust or sell it?

Thanks,
Matt

[talonXracer]

You could try a set of the urethane exhaust hangars.

[nos4mao]

Where do I find those at because I found these exhaust hangers made by Cusco. Not sure what to think of them?

Thanks,
Matt

[Amoney47]

fixed it i just ziptied that hoe

[kev12345]

does it hit the stock exhaust too?

[socmex7]

does it hit the stock exhaust too?

mine does.. but i haven't change out the endlinks yet.. and it only vibrates when i'm stopped or it's cold..