Piston Ring info

[crhatch02]

Alright Im in need of some piston rings for my swap....what I need to know is, will stock rings be fine or will I need to get supertech or JE from crsx.....along with that what is the difference between the 2 other than 50 Dollars? Its for an A1 bottom end with k24a2 pistons

[ep3k20a2]

might be for oversized rings.... not sure I will let the pros tell u

[Lucid Moments]

What swap are you doing and what pistons are you using? If you buy aftermarket pistons then they will come with the correct rings to use with them. If you are using stock pistons then I would use the stock rings.

[crhatch02]

What swap are you doing and what pistons are you using? If you buy aftermarket pistons then they will come with the correct rings to use with them. If you are using stock pistons then I would use the stock rings.

k that's what I needed to know...the pistons are from an 04 tsx...you wouldn't happen to have a part number for the rings would ya?

[Lucid Moments]

k that's what I needed to know...the pistons are from an 04 tsx...you wouldn't happen to have a part number for the rings would ya?

Look here (http://www.acuraautomotiveparts.org/acura/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=TSX&catcgry2=2004&catcgry3=4DR+TSX&catcgry4=KA6MT&catcgry5=CRANKSHAFT-PISTON&ListAll=All&vinsrch=no&systemcomp=Engine&vinnoT=&trim=&trans=&view=normal)

According to that it should be either 13011-RBB-004 or 13011-RBB-006 and I don't really believe there is much of a difference.

[crhatch02]

Look here (http://www.acuraautomotiveparts.org/acura/jsp/mws/prddisplay.jsp?inputstate=5&catcgry1=TSX&catcgry2=2004&catcgry3=4DR+TSX&catcgry4=KA6MT&catcgry5=CRANKSHAFT-PISTON&ListAll=All&vinsrch=no&systemcomp=Engine&vinnoT=&trim=&trans=&view=normal)

According to that it should be either 13011-RBB-004 or 13011-RBB-006 and I don't really believe there is much of a difference.

awesome..thanks for the help

[davisj3537]

Chase get the stock 04 bearings too sir!

[Gilmour]

Yes use the Honda rings.