Tranny question!!!!

[27rocks]

Do i need to unbolt starter to drop the tranny? it seems like i unbolted everything but its just not coming apart.

[talonXracer]

It is tight on there, there are several dowell pins. Make sure to support the trans and use a dead blow hammer and or a block of wood and use those to get it moving apart.

[27rocks]

thats what i though... hammer it is then lol

[talonXracer]

thats what i though... hammer it is then lol

Dont use a regular hammer. Use the rubber/plastic type mallet, or the block of wood and a regular sledge hammer.

[27rocks]

its not coming out!!! ahhhhhhhhhhhhhhhhh :mmad:

[27rocks]

i can move it on the fire wall side but its not moving at all towards the front

[talonXracer]

There is a bolt that goes from the starter side into the trans on the front. Make sure the coolant tube is free enough to allow movement(across end of head and trans).

[27rocks]

i know i got that out...its the one right under the starter right? Right behind the bracket for the front motor mount.... am i close?

[27rocks]

ok im about to start day two lol

[27rocks]

Do i have to take the starter off???

[talonXracer]

It wouldnt hurt to unbolt it and pull it out slightly. I know there are more than one thread that has been posted that has pics and directions. Try a search here and the DIY section.

[27rocks]

everything got lost in the crash.... i got it loose but now that stupid engine mount wont let me get it out... im so frusturated

[27rocks]

ok i got her off a little while ago... it was fun :mrolleyes:

[liquid cooled]

Service manual... use it.... or at least I hope you did.

[27rocks]

nope lol just kinda went along

[T_Virus]

what happen? Didn't we just saw your ep last week at the meet?

[27rocks]

Im all done!!!!!!!!!!!!!


Yeah i blew a CMC the other day and it was my 3rd one. I asked for some help and got guided in the right direction, so i figured since i have a couple of days off i might as well fix the problem.

[T_Virus]

wow 3rd one...well atleast it is taken care of...