Sparco Pedal installation help!

[lbk02si]

hey guys, i just purchased some Sparco grip pedals, and was noticing thats its a muther F#$%'er to figure out where to drill the holes! i already messed up on the clutch pedal and drilled too close to the bar the actual pedal is mounted to. Can anyone give me some help on the easy way to install these??

[OZ.EP3]

Here's what I did when I installed my StrutKing Pedal set:

-Remove the factory rubber covers from the clutch and brake pedals
-Cover all you pedals with blue painters tape
-Place your new pedal on with a piece of tape
-Line up your pedals! (this is your only chance to make sure their even, sit back in your drivers seat and look at their position, re-position as necessary)
-Now you can mark your drilling holes
-Before drilling check the backside for clearance, re-tape and mark if not
-Use a metal punch on your drilling marks(this is important if you want all your drilled holes to line up)
-Remove the tape and drill away(start with the smallest drill bit that you can and progressively go up to your desired size. I started mine with a 1/16 bit...)
-Use Locktite on your threads and you'll never have to retighten your screws