PDA

View Full Version : One piece fibreglass front?



Hasbro
09-10-2008, 03:10 PM
Does anyone make a one piece front for the EP3 for the track?

illusionsoflife
09-10-2008, 04:09 PM
what are you asking exactly. like a whole front bumper? if so then yes. there is a lot

buddy club front is nice. i had it but i hit a carwith it and it completly shattered. i was going so slow my gaugewas still at 0 mph

Hasbro
09-10-2008, 06:04 PM
No, it's a one piece that encompasses the entire front, from the front of the doors/windshield forward. Front fenders, hood, bumper, all one piece.

civictype_r04
09-10-2008, 06:19 PM
Not for the ep man.

EP3_U_SEE
09-10-2008, 06:31 PM
i think they only make it for drag cars

Hasbro
09-10-2008, 07:46 PM
Not for the ep man.

I couldn't find one so that's what I expected. Maybe in England but the shipping...
Thanks.

MugenReplica
09-10-2008, 09:06 PM
I'm thinking Franks is going to be your best bet.......

Not Ep3, but EM2. He does custom work also.
http://www.frankscustomfiberglass.com/01-04_civic.htm

http://www.frankscustomfiberglass.com/images/DSCF0981.JPG


Mustclime had a good link to a RSX front end. Similar pricing to above, perhaps a little cheaper.

MugenReplica
09-10-2008, 09:22 PM
Make sure you PM Mustclime and thank him for this....

http://www.riggeals.com/index.htm

Used to have a full RSX front end on their site. For some reason it's gone, but you should still be able to PM them and ask them about it. Hope that helps! They had a CF full front end also.

Hasbro
09-10-2008, 10:28 PM
Very good but neither have an EP3 front. I've seen Frank's before, very close. It would be cool if an RSX front fit!...

benkieboy
09-11-2008, 12:33 PM
rsx front might fit with a few modifications but i wouldnt be a fan of it.