PDA

View Full Version : Help running Wires



whtep19
11-28-2002, 05:41 PM
Can somebody tell me how the plastic pieces lift up so i can run my remote, wires and rcas? I tried prying them but i don't want to break any of the pieces. The ones nearest to the rear speaker seem to be giving the most trouble.

Jpax
11-28-2002, 09:30 PM
if you take out the back seat the bottom part you can run the wires to the rear speakers or to the back of the car, the rear seat has a 10mm bolt near the center of the seat, take that bolt out and pull up on the seat in front, its just cliped onto the chassis...then you will see a huge hole that you can run the wire to each speaker....... simple.

2k2SiAutoXer
11-28-2002, 11:13 PM
hey whtep19, where are you located in jersey?
--Tom

whtep19
11-29-2002, 09:08 AM
I was trying to run the wires to my box in the rear not to the rears but ill try taking to seat out thing and see if that helps. I'm located in South Jersey (Berlin)

BlasTech
11-29-2002, 09:19 AM
Paxie, I want to take my back seats out to see if I like it better. (I did on my old 84 hatch). I can see a bolt that holds the middle joint in place, but theres another bolt just like it that I cant get to (its covered with steel) attached to the same part...maybe thats not the right peice?

Can you be more specific or provide a picture of how to get the back seats out?

Jpax
11-29-2002, 10:01 AM
Originally posted by BlasTech
Paxie, I want to take my back seats out to see if I like it better. (I did on my old 84 hatch). I can see a bolt that holds the middle joint in place, but theres another bolt just like it that I cant get to (its covered with steel) attached to the same part...maybe thats not the right peice?

Can you be more specific or provide a picture of how to get the back seats out?



http://www.digitalpose.com/mbr/511/9488/p/145265_1679735055248009530_vl.jpg

/\ This is were it snaps out of.....pul very hard, it wont break, there are two on on each side near front of back seat.

http://www.digitalpose.com/mbr/511/9488/p/145266_251143148789881933_vl.jpg

/\ this is were the 10mm bolt is.....unscrew it and thats it...

http://www.digitalpose.com/mbr/511/9488/p/145267_8802184294887737870_vl.jpg
Then you can run wires ...

BlasTech
11-29-2002, 10:14 AM
thanks!