Buddy Club Pro Spec Exhaust install

[str8upballur]

is there a thread of an install on a buddy club pro spec exhaust? i just bought one for $125 off of craigslist and was wondering if there's a write up on an install. ive looked but cant find one.

[Twisted-X]

I would imagine it couldn't be that much different from any other exhaust installation. Jack up the rear of the car and support it on jack-stands following the jack-points in your manual. Spray all the bolts you want to remove with PBlaster, wait 30 minutes, spray 'em again. Then remove the two bolts/nuts from the axle-back, remove the rubber insulators, remove axle-back. Remove three bolts/nuts from back of catalytic converter, remove rubber insulators on mid-pipe, remove mid-pipe. Installation is reverse of removal. Remember to torque the bolts to spec.
16 ft/lbs on axle-back, 25 ft/lbs on cat-back

Depending on how rusty some of this hardware is, you may have to cut it off, or apply some heat.

[str8upballur]

thanks. ill be installing it monday since i work tonight and mothers day is tmorrow. we'll see how it goes.