View Full Version : "BRAKE" and "ABS" light on the dash
tru3aznplayaz
08-02-2010, 04:14 PM
well when I start my car up the lights are not on..its when I start driving awhile and then both lights comes on..i dont know what wrong..i check the fluid and its all good..any suggestions?..
Tougeep3
08-02-2010, 06:45 PM
Sounds like you need someone to look at the ABS system. scan tool required I believe, unless the back door trick works with ABS codes also..
BTW when the ABS light is on the ABS does NOT work. Just FYI..
RHCP0801
08-02-2010, 06:46 PM
need to get the codes read
27rocks
08-02-2010, 07:33 PM
Check the sensors. Make sure they are tight and in there. If they are and everything seems normal then go get it scanned.
tru3aznplayaz
08-03-2010, 02:42 PM
ok ill look at the sensors..thanks..
RedSiBaron
08-03-2010, 06:14 PM
go to a honda dealer and have them read the codes, i know it sucks but it will be about $50...its not the obd port and autoparts stores dont have the reader...ive been driving with an abs light for 2 years now because i dont want to spend the money to find out which of my 4 abs sensors dont work...and i know its 1-4 of the sensors that arent working...i just dont care that much to make my abs work...
robhep3
08-03-2010, 07:06 PM
Keep in mind that Red's approach is probably not the wisest for the average driver...
RHCP0801
08-03-2010, 07:39 PM
go to a honda dealer and have them read the codes, i know it sucks but it will be about $50...its not the obd port and autoparts stores dont have the reader...ive been driving with an abs light for 2 years now because i dont want to spend the money to find out which of my 4 abs sensors dont work...and i know its 1-4 of the sensors that arent working...i just dont care that much to make my abs work...
i have qouted you before on this, it is the OBD2 port you use to read abs codes. I worked at firestone and there reader was through the OBD2 port and so was the Honda dealer i worked at...there are no other ports that you can plug in
Tougeep3
08-03-2010, 10:46 PM
go to a honda dealer and have them read the codes, i know it sucks but it will be about $50...its not the obd port and autoparts stores dont have the reader...ive been driving with an abs light for 2 years now because i dont want to spend the money to find out which of my 4 abs sensors dont work...and i know its 1-4 of the sensors that arent working...i just dont care that much to make my abs work...
Got a DMM? Unplug the sensor, set your meter on A/C volts, attach meter to sensor, spin the wheel. If the voltage changes that sensor is ok, go to the next one...
tru3aznplayaz
08-15-2010, 06:16 PM
ill just try the dealer..
EP3driver
08-15-2010, 07:20 PM
If lights come on you have a code stored...try resetting the ABS light. It could also be a bad cable reel.
tru3aznplayaz
08-15-2010, 08:02 PM
how do i reset it?
EP3driver
08-17-2010, 04:04 PM
go to honda-tech.com and there is a link in their FAQ/DIY section...same procedure for our cars.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.