How to mod wing for usdm hatch?!

[PatrickJamesYu]

Yeauhh
How should I go about modding it?
I have the batman wing and the ctr rep.
Both don't sit flush with my usdm hatch.

I'm not sure How I should go about taking away some of the material.

What would be the best, most effective, and precise ways of doing this?
Anyone in the San Gabriel, Inland Empire areas wanna help me out?!
:D

Photoshoot for your wing modding labor :D

[PatrickJamesYu]

B Ump

[RedSiBaron]

take a look at it and see where its hitting, then do some minor shaving on that area, rinse and repeat essentially, same holds true for shaving the authentic type r lip...

[PatrickJamesYu]

by shave, what tool are you referring to?

I have an idea on what i need to do
(which idealy is quite obvious by looking at it)
but I don't know how to go about doing it.

[ShadowEP3]

use a dremel

http://www.248am.com/images/dremel300.jpg

[Kerby]

batman wing huh? are you refering to the Buddy club wing? hehehehe it does look like a batman wing.

[RedSiBaron]

by shave, what tool are you referring to?

I have an idea on what i need to do
(which idealy is quite obvious by looking at it)
but I don't know how to go about doing it.

dremel works, but i used an electric grinder with a thick grinding wheel...that worked very well and quick, but i have also used that particular tool a lot and thus have good control over it, if you've never used one i say go with the dremel so you dont take too much off

[Sucka]

I would help you out but im in the oc area.

[PatrickJamesYu]

I pass through westminster all the time
seal beach, huntington :D

[Sucka]

I pass through westminster all the time
seal beach, huntington :D

Yep that would be me! But i don't have a dremel.