PDA

View Full Version : automatic K24a2 question ?



LOVIN MY EP3
10-19-2010, 01:50 PM
As stated will it be able to swap into my ep3 tranny ?

chiwhitesi
10-19-2010, 02:36 PM
yes, you need some different part though i can't remember off the top of my head.

clutch/ flywheel/ pressure plate

throwout bearing?

RHCP0801
10-19-2010, 02:55 PM
no you dont need any new parts, i took an automatic k24a2 and bolted it right up to my ep3 trans without changing anything...i did change the pilot bearing because thats hard to change and its better to be safe and put in a new one while the tranny is out than waiting for it to go while its all bolted up....plus its only like $20

LOVIN MY EP3
10-19-2010, 02:59 PM
I Have all that on my EP3 stage 1 exedy clutch and flywheel package

RHCP0801
10-19-2010, 03:01 PM
you can leave it, it will bolt right up...if the engine came with a torque plate just take that off, mine did

LOVIN MY EP3
10-19-2010, 03:02 PM
no you dont need any new parts, i took an automatic k24a2 and bolted it right up to my ep3 trans without changing anything...i did change the pilot bearing because thats hard to change and its better to be safe and put in a new one while the tranny is out than waiting for it to go while its all bolted up....plus its only like $20

okay thanks alot sir