PDA

View Full Version : Install question JDM "H" badge



SiRman
12-14-2002, 12:02 AM
Hello everyone, this is my first post. Just picked up my 02 silver SiR
yesterday. I got a set of JDM CTR H badges. after holding the front one up
the front of my stock one, the JDM one appears slightly smaller.
Has anyone ran into any problems installing theirs? Shop I got the badges from mentioned removing the mount plate all together, is this what has to be done?

IceD out N CALI
12-14-2002, 12:33 AM
just pull the front part of the bumper back. (you move it back by pulling those i think 8 plastic screws that hold the front part of the bumper) and it is 2 phillips screws that holds that platform in. simply remove them and behind it is a flat base. that flat base is where the CTR emblem goes onto:)

IceD out N CALI
12-14-2002, 12:33 AM
oh yeah, and welcome to the site

SiRman
12-14-2002, 09:53 AM
Thanks for the reply and the welcome, just wanted to make sure it was the right one before started pulling it appart.