OBX rh bolt up to my apexi ws2???

[Garrett]

need to know if my obx v2 rh will bolt up to my apexi ws2 catback exhaustt.. didn't look that up and need to know!

[Passenger]

Yes, Im not sure if OBX made a EP3 spec rh but the DC5 will fit, you just have to get it cut at any muffler shop to fit cause its around an inch or two too long.

[Garrett]

shittt, so it won't just bolt up right away? i have to get it cut to make it fit?

[Garrett]

bumppp need to know asapppp

[Passenger]

shittt, so it won't just bolt up right away? i have to get it cut to make it fit?

Yes if it's RSX spec you'll need it cut 2 or 3"
Sorry I didnt get to reply earlier. Any muffler shop should be able to do it for $10-$30

[Garrett]

Alright well that sucksss hahaaa.. i thought it would bolt right on up.. whateverrr i'll look into shops around me!

[monjarassi]

it should work garret try it out...

[Garrett]

Alright i shot you a pm too.. i thought i bolted right up.. i'm gonna do a little test fit tomorrow since my head is already off anyway haha

[T_Virus]

if everything is all ep3 spec as in ep3 obx rh and ep3 apexi ws2, then it should fit. It gets kinda tricky when you swap in the dc5 specs which requires modification from a muffler shop like said above.

[Passenger]

if everything is all ep3 spec as in ep3 obx rh and ep3 apexi ws2, then it should fit. It gets kinda tricky when you swap in the dc5 specs which requires modification from a muffler shop like said above.
:yeahthat: like I said, I assumed it was DC5 spec cause you didn't say it was made for the EP3. But yeah any toothless hillbilly at one of those can do that for nearly dirt cheap.