prob imobilizer and remote starter

[ptate]

so here is the deal. my car wont start because it dont reconize my key...

so i went to the dealer to reprogram my key chip
suprise! it didnt work
so the guy at the dealer told me it was probably the imobilizer or if i had a remote starter maybe it was that!

so i chek under my dash back home and suprise! there were a power start box and all the wiring for a remote starter with my gray valet key in the box!
here everything
http://i171.photobucket.com/albums/u289/ptate3/DSCN2332.jpg?t=1290537005
http://i171.photobucket.com/albums/u289/ptate3/DSCN2336.jpg?t=1290537005
here is the 2nd box with the valet key to jumpstart the imobilizer and a key chain?? wtf
http://i171.photobucket.com/albums/u289/ptate3/DSCN2337.jpg?t=1290537005

here is all the wiring
http://i171.photobucket.com/albums/u289/ptate3/DSCN2334.jpg?t=1290537005

imobilizer
http://i171.photobucket.com/albums/u289/ptate3/DSCN2333.jpg?t=1290537005

and thats a switch and a push buton??? what the hell is that for???
http://i171.photobucket.com/albums/u289/ptate3/DSCN2335.jpg?t=1290537005

so i unplug enverything and the car wont start again. do i have to plug some of those wire back somewere or i defenatly change the imobilizer (cost 260$ at the dealer)??

thanks guys

[RHCP0801]

the switch is to turn the remote start on and off, if you want it to work turn it on, i have the same thing in my car but not sure what the button is for

and did this happen out of no where?

[ptate]

i tryed with the switch on and it didnt work! and yes it happen out of no where

[ptate]

no one?

[musashi1219]

is the immobilizer light flashing when you try and start the car? if yes then it should not have anything to do with the alarm/starter and the push button is for programming the remote starter.