PDA

View Full Version : RBC with aftermarket TB



LOVIN MY EP3
11-26-2010, 09:21 PM
with the RBC manifold and a aftermarket 70mm. TB would you need to bore the manifold ?

Tnhatch03
11-26-2010, 10:07 PM
you do not need to. but would be beneficial.

LOVIN MY EP3
11-26-2010, 10:37 PM
I was told that its actually worst than have the stock TB on as far as performance

Tnhatch03
11-26-2010, 11:07 PM
you have a swap?

it may depend on the motor setup you have.

LOVIN MY EP3
11-27-2010, 12:02 AM
I have a K24a2

Tnhatch03
11-27-2010, 12:40 PM
guess i coulda saw the big red K24A2 sig. ;-)

i am not sure the comparison of the RBC on a K24 manifolds and what the differences are.

but if you can get more air in there, the better.

talonXracer
11-27-2010, 05:46 PM
You need to match the inlet and TB size.

LOVIN MY EP3
11-27-2010, 11:21 PM
guess i coulda saw the big red K24A2 sig. ;-)

i am not sure the comparison of the RBC on a K24 manifolds and what the differences are.

but if you can get more air in there, the better. lol its okay RBC is really good for top end


You need to match the inlet and TB size.

Time to start looking for a machine shop