PDA

View Full Version : Problem CEL / EP3R EDM !



nesty_2
01-06-2011, 09:55 PM
Hii im from Dominican Republic i own de Only EDM EP3R in the country !!
I have some problems ... My car have CEL light on ... The codes are CAMSHAFT SENSOR ... O2 PRIMARY SENSOR.... Plus I have a PRC Ecu On (i think this is the Problem) The old owner Had KPRO but He sold the EP with PRC (NOT THE FACTORY PRA) the car is Very slow IDK what to do Cuz Its a EP3R it has to Run Like a Champ Help Me on this One !! One Pic Of the car ... Sorry for quality is PHONE PIC and sorry for my bad english (EP3R EDM FACTORY ENGINE IS K20A2)

dnrprojectsvp
01-18-2011, 12:30 AM
is the camshaft sensor code for phase gap?

talonXracer
01-18-2011, 06:30 AM
The PRC ECU will not control the engine properly, the stock ECU should be installed or better yet get Kpro.

The PRC uses the jdm NARROW band o2 sensors, EVERY OTHER market uses wide band o2 sensors.

Camshaft position CEL usually indicates jumped cam timing.

nesty_2
01-25-2011, 01:19 PM
Soo the problem is that my engine is out of time ?? what can i do ?? and thanks in advance ! !

talonXracer
01-27-2011, 09:06 AM
First off verify the cam/cam chain timing. Then report back.

Install the original stock ECU or a Kpro equipped PRB ECU.

nesty_2
01-27-2011, 01:14 PM
How can i verify the cam chain timing ?

JayRSXS
01-27-2011, 06:35 PM
Ecu then i guess

k20power
01-28-2011, 04:06 PM
there is a lot off good machanics in dr I know if u ask around there u will find one that can help u..there is a lot of other ep3s there too