Time to choose a header!

[Tortoise]

Hey guys, gettin ready to do my k24a1. Jus gotta finish gatherin up parts. Its come time to choose a header and i havent really found a thread for the k24a1. My budget for a header is about 450. Which one should i choose out of the ones below based on gains,build,and fit? Thanks so much guys!
crsx
http://www.clubrsx.com/clubep3/CLU-SSRH.html
strup
http://www.clubrsx.com/clubep3/SPU-HC21202.html
Dc stainless
http://www.clubrsx.com/clubep3/DCS-HSR5523.html

Also is this the right cel eliminator to use and how does it work?
http://www.clubrsx.com/clubep3/CLU-CEL-ANG.html

All input is greatly needed and appreciated. Thanks a lot ephatch

[AKEP]

Hey guys, gettin ready to do my k24a1. Jus gotta finish gatherin up parts. Its come time to choose a header and i havent really found a thread for the k24a1. My budget for a header is about 450. Which one should i choose out of the ones below based on gains,build,and fit? Thanks so much guys!
crsx
http://www.clubrsx.com/clubep3/CLU-SSRH.html
strup
http://www.clubrsx.com/clubep3/SPU-HC21202.html
Dc stainless
http://www.clubrsx.com/clubep3/DCS-HSR5523.html

Also is this the right cel eliminator to use and how does it work?
http://www.clubrsx.com/clubep3/CLU-CEL-ANG.html

All input is greatly needed and appreciated. Thanks a lot ephatch

that CRSX header is probably the same as the Private Label/Kiddracing header, since i have those pictures on Witz Racings' FS thread. I dont think it will clear the stock ep sway with a k24 in it. I've read on here that that DC will take a swap, IDK about the strup, but the way a BCRH looks, i think that will also clear a k24 swap.

I've never seen that o2 sim, but im sure it works all the same. Good luck

[ilovehaters]

that's the correct cel eliminator.. are you dropping in a stock a1?

[AUTiger]

I have a k24a1 with the private label/kiddracing/clubrsx raceheader. The shop that installed the k24 just transferred it over from the a3. They said that there were no clearance issues and I have no problems other than some rattling of the resonator on my type-s midpipe, but if I remove the heatshield the rattling would go away.

However, I do have an 02 EP3 which has the sway bar with the most clearance.

[Tortoise]

that's the correct cel eliminator.. are you dropping in a stock a1?

Yes just a stock a1 with boltons

[Tortoise]

66 views and 4 responses....thanks guys

[sbRR]

Club RSX stop carrying those. They are now working with a different company. You won't have any problems with DC. I don't know about Strup. With the Private Label(CRRH), a lot of people seem to be having clearance problems. Private Label does make the most power out of the 3, though.

[civictype_r04]

Get the DC sports one dude!!!