k24a1 setup good for turbo?

[civicsiep3]

hello i have had an 04 ep3 with a k24a1 swap for a while and now i FINALLY have the money to turbo it. i was kinda wanting to do 10:1 comp pistons and turbotuff i-beam rods. i know most people use 9:1 comp for boost but i am thinkin if i run 10:1 or 10.5:1 comp pistons i can get really good response need lower boost to acheive my goal(400ish with gt3076r) i just havent seen anyone run higher comp pistons on their turbo k24's i know people are making 400hp= on higher comp k20's so i assume the k24 esp with these rods should have no prob but what do you think? do you tihnk i should just go 9:1 or do you think 10:1+ will be better cause i am looking for the best response.
other parts to this build i already have are 70mm throttle body port matched intake manifold 3'' exhaust and obv kproo

[gtimportfanatic]

im doing a high comp turbo build on my k24a4.. not alotta hatchers go down the road.. but other forums will open your eyes to the k series engine and what it can do for you.. try it out and see... but.. just so you know.. Monjarassi and Superchargedk20 both have k24a1 stock motors on boost.. and both cars rip