Skunk2 Parts

[Danielsle]

I was looking into getting a skunk2 intake manifold and a composite fuel rail.

http://passwordjdm.com/Skunk2-Black-Series-K20-K24-Pro-Series-Intake-Manifold-P7535C1308.aspx

http://passwordjdm.com/Skunk2-K-Series-Composite-Fuel-Rail-02-05-Civic-Si-02-06-RSX-P2949C859.aspx

I was just wondering if anyone has them already? If so, would they be direct plug and play? Or would I need to shave or cut anything, for any missing sensors?

[talonXracer]

If your intent is bling horsepower, these would excel, BUT without Kpro and other supporting mod's the intake mani would be a downgrade from stock.

They are supposedly plug and play.

[Danielsle]

Kpro is already en route to my house. I do plan on blinging out my HP. I had my first EG hatch and everything was poorly done to increase power. But now I am only doing this project with high quality equipment. But thank you for the information. Plug and play is the way I like it!

[05 hatch]

The rbc im is good. A member here was selling a fully polished one on k20a.org. you might wanna check that out. Supa bling bling!

Sent from my Droid using Tapatalk

[vicx52o]

I'd go with a moddified RBC.... that skunk2 IM is WAY too overpriced.

[RHCP0801]

^^^ yup, all your spending the extra money on is a skunk2 nameplate and that doesnt really impress anyone these days

[vicx52o]

If you have the money and if you plan on building a k20 or k24 you should look into an 'RRC' IM. It's the IM used on the FD2-R's. Kinda pricey but from what i've researched / read, it outperforms the RBC.

[T_Virus]

Kpro is already en route to my house. I do plan on blinging out my HP. I had my first EG hatch and everything was poorly done to increase power. But now I am only doing this project with high quality equipment. But thank you for the information. Plug and play is the way I like it!

You got to start thinking K-Series and not B/D Series. Skunk2 was favorable for B/D Series, but K-Series is on a whole new level. There are way better parts out there than Skunk2.