View Full Version : DIY extended wheel studs replacement?
ep-unit
04-21-2011, 04:32 PM
anyone has extended wheel studs on their ep? i just purchased some for the front and was looking to see if there was a DIY on the ep somewhere
STP03BlueSI
04-21-2011, 07:16 PM
Have to have the front hub bearing pressed to replace the fronts. Rears just slam out with the mighty thor hammer.
ep-unit
04-21-2011, 07:23 PM
Have to have the front hub bearing pressed to replace the fronts. Rears just slam out with the mighty thor hammer.
will i have to buy any new parts if I have the hub bearing pressed out
STP03BlueSI
04-23-2011, 06:41 AM
will i have to buy any new parts if I have the hub bearing pressed out
prob 2 front new bearings...unless you can have someone press it out with out damaging it.
donsep3
04-23-2011, 11:10 AM
u dont need to press ep hubs because i broke 2 out of 4 studs on my and i ask the dealer if u need to press it!
x3thelast
04-23-2011, 11:19 AM
i went ahead and replaced my front bearings. the rear studs had to be air hammered out... -_-
STP03BlueSI
05-18-2011, 04:57 PM
u dont need to press ep hubs because i broke 2 out of 4 studs on my and i ask the dealer if u need to press it!
How the hell did you break 2 out of 4...and would love to know how your dealer swapped them out.
ep3jd
05-18-2011, 05:57 PM
I've replaced studs on all corners and never needed to press anything. Just saying.
ep-unit
05-18-2011, 06:00 PM
I've replaced studs on all corners and never needed to press anything. Just saying.
on the ep? Any tips
ep3jd
05-18-2011, 06:06 PM
Yeah get them in and use an open ended nut to crank em down straight.
I guarantee someone will say otherwise but it worked for me, so fuck it.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.