Modify wire harness after RBC install?

[bchaney]

Did you guys have to modify the wire harness after installing your RBC IM? Mine doesn't seem long enough to reach the throttle position sensor and if I plug in the sensors near the starter the plug for the IAC won't reach either.

Karcepts' instructions don't mention modifying the wire harness and I've never read that this is required - am I doing something wrong?

[POOPTOOTH]

I didn't have to, just play with it a little while, I'm sure you'll figure it out.

[talonXracer]

You will need to run it a little differently, nothing major, there is no need to do any splicing soldering cutting wires or crap like that, just a re-arrangement, pull back the outer cable sheath on the harness and you will see what needs to be done.