Flywheel Weight

[Blah1219]

So I just picked up a flywheel of a forum. I'm just wondering what the weight specs are on the k20a3, k20a2, and k20a flywheels. Can't find it anywhere or I'm just blind.

[VIZHUNZ02SI]

k20a=10.25 lbs, k20a2=16-717lbs, k20a3 little heavier than the a2 but not by much
k20a.org is your friend

[Blah1219]

that's where I got the flywheel. I got the k20a2 flywheel and it weighed 15.2 lbs. Just had to make sure.

[VIZHUNZ02SI]

lol i got a k20a2 in my garage that need a lil resufacing. but i swapped it out for an act 10 lb flywheel i got from 27rocks on here. its a difference on throttle response, just remeber to change your throw out bearing if you're using the same clutch

[Blah1219]

I picked up a stage 2 exedy clutch also. But I need to pick up a throw out bearing. isn't there also another bearing i'm going to need to pick up? I can't find any sites that sale any of the bearings, I'm might have to pick a oem one.

[sLiCk]

The clutch kit usually comes with the throwout and pilot bearing. Unless you bought it used?

[talonXracer]

Usually the throwout bearing is included, but seldom is the pilot bushing included(but some distributors do), but they are super cheap at Honda and they should have them in stock locally, this is about the only time the stealership comes in handy, for little stuff that costs more to ship.

[Blah1219]

I bought it used on k20a.org w/ 5k . Looks like new. Yeah I have a list of bunch of little stuff like misc bolts and washers for my k24a1 swap. Now the throw out bearing and a pilot bushing. Im looking to borrow a clutch alignment tool. Is there a specific one for the k series engines?

[VIZHUNZ02SI]

what else do you need for you k24a1 build?

[Blah1219]

Exhaust springs
exhaust gasket
exhaust donut
exhaust bolts and nuts
water pump gasket
water pump bolts
intake manifold bolts and nuts

im debating on what kind of spark plugs and o2 sensors to run, but I have everything else. After I have everything done Im going to a exhaust shop and replacing my megan pipe for a custom 2.5" pipe combo'd on my dcrh and spoon muffler. She's going to be loud.

[VIZHUNZ02SI]

k24a1 spark plugs,ep3 02 sensor, the 2.5" isnt loud if you put the proper resignator on it. get ride of the dcrh and get krrh.
only thing i have left of my scrap k24a1 is the complete head and chain guides and chain.

[Blah1219]

Im looking at the power rev racing resonator. I just picked up the dcrh. Im going to save up for a spoon sports header. Im a spoon addict!