PDA

View Full Version : adjusting idle afr



AKEP
07-05-2011, 01:06 AM
its at about 20:1, do i just add fuel to the section on the map where the highlighted area is?

i tried this and it didn't do anything, stayed at 20. ?

talonXracer
07-05-2011, 07:16 AM
Do you have open loop selected?

Also check what the idle AF is set at(cant remember the tab used, but you can set a target range for closed loop(uses STFT to ignore the calibration))

AKEP
07-06-2011, 12:06 AM
i'll check it out in the morning.

AKEP
07-07-2011, 08:46 AM
so i put it in open loop, added up to 30% more fuel and it still sits at 19-20 afr...but when i change the overall fuel trim i do see the changes in closed loop.

talonXracer
07-07-2011, 10:45 AM
On the parameters page, idle tab, what is your target lambda set at?

Then on the kpro kmngr screen hit the "options" tab, then select "settings", then select "lambda overlay" and set the proper target lambda you want.

AKEP
07-08-2011, 05:04 AM
14.59:1

lamba overlay looks fine, nothing about idle?

i just noticed that i usually have "follow cam angle" selected and it wasn't, and i remember it not being at 0, so i was looking at the wrong map. lol nub mistake. i'll play with it tomorrow, now that i saw that.

WPB EP3
07-26-2011, 03:08 PM
also, worth mentioning..

make sure your primary o2 is in good working condition.