View Full Version : Roll Cage
civicsi0281
07-23-2011, 08:23 AM
Does anyone have a good set of measurements for a 4 or 6 point roll cage that would pass tech for the EP. I'm not up
to standards on just how to measure for the cage all though I do have a sheet to write them all down and an angle
finder I got sent to me from BD racing in Chicago.LOL! Any help would be appreciated. Thanks
civicsi0281
07-23-2011, 03:44 PM
Bump
Garrett
07-24-2011, 06:25 AM
In for info also
RedSiBaron
07-24-2011, 08:30 AM
Tech for what? Different organizations and classes require different things...
If you want cage specs download the scca rule book and build a cage to their spec, guaranteed it will pass every other organizations spec...
Its not so much angles of tubing or measurements of length, its the way in which you build it and the thickness of tubing wall, and the tubing needs to be DOM (drawn over mandrel) and then the bends all have to be continuous, etc etc...make sure your mounting points to the floor are large enough too...
Like I said, get a rule book
civicsi0281
07-24-2011, 09:45 AM
Thanks bro! Yeah SCCA is what I wanted far as spec and tech goes. Everyone I know that has done a cage is drift guys and you could get by with PVC pipe painted black in there tech hahaha.
Tnhatch03
07-24-2011, 02:52 PM
everyone i know that has done a cage is drift guys and you could get by with pvc pipe painted black in there tech hahaha.
please don't! ;-)
apexracing
07-25-2011, 09:50 AM
please don't! ;-)
christ fail cage lol
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.